Hi there
Anybody who knows about UserGuid and Tutorials for LDPartEditor. I'm new to the app and have a hard time trying to find out how to use the program. I have started a project were I have to make some special parts. I have been using Inventor a lot as a profession. Is there perhaps a possibility to draw the part in Inventor and then convert it to be used in LDPartEditor and further on to STUD.io
Very nice to get an answer on this subject.
erge46
Anybody who knows about UserGuid and Tutorials for LDPartEditor. I'm new to the app and have a hard time trying to find out how to use the program. I have started a project were I have to make some special parts. I have been using Inventor a lot as a profession. Is there perhaps a possibility to draw the part in Inventor and then convert it to be used in LDPartEditor and further on to STUD.io
Very nice to get an answer on this subject.
erge46