LPub - rotate submodel in PLI

[Jaco van der Molen]

In order to more clearly indicate that a (previously built) submodel is attached in a certain step, I want to include it in the PLI.
The orientation of the submodel in the PLI makes is different from the orientation in the step-by-step instructions for building it.
How can I get the submodel to show up in the PLI with the same rotation as the in the building instructions of that submodel?

I think the orientation could be caused by a rotation step somewhere in the model.
I usually start my submodels with

Code:

0 ROTSTEP END

This often solves a lot.
Orientate the submodel the right way in your model so that front, back, left, right are indeed what you mean to show in the PLI.

Perhaps it is also possible to add your submodel to the custom pli.ldr file where you can influence the orientation of parts in the PLI and BOM.
Never tried that though.