LDCad 1.6 - Placement Arrows?


RE: LDCad 1.6 - Placement Arrows?
#3
(2018-05-27, 0:23)Andy Dassing Wrote: What's the recommended procedure in LDCad to indicate part/assembly placement using arrows, lines, and inset bubbles?  Here's a link to an example:

https://sites.google.com/site/workingwithlpub/_/rsrc/1454413877598/lpub-4/working-with-submodels/using-a-callout/PointingOutPartsExamples.gif

Needs and Concerns:
  • BUFEXCHG is needed?
  • With and without subfile assemblies?
  • CLEAR commands needed?
  • Custom arrows, dashed/dotted lines, bubble callouts, etc?
  • Prevent part duplication in the parts list?
  • Clear and understandable rendering in LDCad
I understand that much of this can be accomplished (somewhat) by hand editing and LPub tweaking, but I'd like to do it all in LDCad if possible.

Can this be done in 1.6x, or will this something better suited to 2.x?

Single part call-out (like my example) is only one part in a submodel called out. The arrow is generated by LPub.

Buffer exchange is more useful for subassemblies (consisting of one or more parts) that hover in one step and are in place in the next.
Arrows or dashed/dotted lines pointing to where the subassembly must go have to be made in LDraw as a "helper part"


Buffering a part or subassembly in one step and change, move or remove in 2 or more steps later can be done with the REMOVE GROUP meta in LPub, using (old) MLCad's Group meta.

LPub should be able to prevent false part counts. If not, this can only be corrected by hand by ignoring a certain part.

The CLEAR metacommand is outdated (I think) and was used in very old versions of LDraw (not sure though)
Jaco van der Molen
lpub.binarybricks.nl
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LDCad 1.6 - Placement Arrows? - by Jaco van der Molen - 2018-05-29, 11:45

Forum Jump:


Users browsing this thread: 3 Guest(s)