LPub ROTSTEP - easy rotation?

[Jaco van der Molen]

One of my biggest problems when using LPub is rotating models to show where a part is attached. I can normally work ut 90º increments in my head, but when it comes down to a more complex rotation I am at a complete loss.

I have seen I can rotate the model using the LeoCAD pane in LPub, but have not found a way to extract the rotation information and use it as a ROTSTEP command. Is there an easy way to do this? There must be a better way to go about this than to punch in some numbers and hope for the best....

I use good old MLCad for complex rotation steps...