Buffer Exchange Fault

[Johann Eisner]

Hi
If you are working with LPub3D than use this Code

1 0 420 -8 -460 0 0 1 0 1 0 -1 0 0 3068b.dat
1 0 460 -8 -460 0 0 1 0 1 0 -1 0 0 3068b.dat
0 STEP
1 0 -20 -8 -430 -1 0 0 0 1 0 0 0 -1 3069b.dat
1 0 60 -8 -390 -1 0 0 0 1 0 0 0 -1 3069b.dat
1 0 180 -8 -370 -1 0 0 0 1 0 0 0 -1 3069b.dat
1 0 -100 -8 -370 -1 0 0 0 1 0 0 0 -1 3069b.dat
1 0 380 -8 -380 0 0 1 0 1 0 -1 0 0 3068b.dat
1 0 420 -8 -380 0 0 1 0 1 0 -1 0 0 3068b.dat
0 BUFEXCHG A STORE
1 0 -270 -64 -470 0 0 1 0 1 0 -1 0 0 3069b.dat
0 MLCAD ARROW 0 -250 -18 -470 0 1 0 -1 0 0 0 0 1  10 4 12 40  3 30 1 2  4 4
0 MLCAD SKIP_BEGIN
3 4 -250 -6 -470 -255 -21 -470 -250 -16 -470
3 4 -250 -6 -470 -245 -21 -470 -250 -16 -470
3 4 -250 -16 -470 -252 -18 -470 -248 -18 -470
4 4 -252 -18 -470 -252 -58 -470 -248 -58 -470 -248 -18 -470
0 MLCAD SKIP_END
0 STEP
0 BUFEXCHG A RETRIEVE
0 !LPUB PART BEGIN IGN
1 0 -250 -8 -460 0 0 1 0 1 0 -1 0 0 3069b.dat
0 !LPUB PART END
1 0 460 -8 -370 -1 0 0 0 1 0 0 0 -1 3069b.dat
1 0 260 -8 -430 -1 0 0 0 1 0 0 0 -1 3069b.dat
1 0 340 -8 -390 -1 0 0 0 1 0 0 0 -1 3069b.dat
0 STEP
1 15 -120 -8 -430 1 0 0 0 1 0 0 0 1 4162.dat
1 15 -80 -8 -410 1 0 0 0 1 0 0 0 1 4162.dat
0

Johann,

Awesome! That worked perfectly thanks! I had been trying to get it working for over a day   

So how does the extra line of code work if you don't mind me asking ? Does it just tell Lpub to ignore that part ?

Again Thanks!

Hi Tom

Yes.
All parts between "!LPUB PART BEGIN IGN" and "!LPUB PART END" are ignored.
So it is very important not to forget the "! LPUB PART END", otherwise all parts will be ignored immediately.

Regards Johann