(2018-02-22, 11:31)Jaco van der Molen Wrote: I see that part 85984 (better known as cheese slope 1x2) misses snap meta at underside so it won't snap at a 90 degree angle on say a 1x2 brick with studs on side.
I cannot remember having problems with that part, but now it does not snap.
I see part 85985 is not made with the subpart without top face that is used for patterned versions of this slope.
The the patterned variants of 85985 use 85985s01 which has the snap meta.
Shouldn't part 85984 be fixed and make use of the 85985s01 too?
I've corrected that part while working on the 17-01 snapping info, mostly thinking it was a recent change as I eyeball all parts in the sorted branch using F11
Info should indeed be in 85984s01.dat