Following up on the discussion on MLCad 3.50 which led to discussing snap meta in LDCad here is something I found.
I see that part 85984 (better known as cheese slope 1x2) misses snap meta at underside so it won't snap at a 90 degree angle on say a 1x2 brick with studs on side.
I cannot remember having problems with that part, but now it does not snap.
I see part 85985 is not made with the subpart without top face that is used for patterned versions of this slope.
The the patterned variants of 85985 use 85985s01 which has the snap meta.
Shouldn't part 85984 be fixed and make use of the 85985s01 too?
I see that part 85984 (better known as cheese slope 1x2) misses snap meta at underside so it won't snap at a 90 degree angle on say a 1x2 brick with studs on side.
I cannot remember having problems with that part, but now it does not snap.
I see part 85985 is not made with the subpart without top face that is used for patterned versions of this slope.
The the patterned variants of 85985 use 85985s01 which has the snap meta.
Shouldn't part 85984 be fixed and make use of the 85985s01 too?
Jaco van der Molen
lpub.binarybricks.nl
lpub.binarybricks.nl