MLCad 3.50 is available

[Roland Melkert]

Thanks for adjusting the snapping information. How to implement this now?

You need to unpack the shadow (%appdata%/ldcad/shadow/offLib/offLibShadow.csl which is a normal zip) library and adjust the LDraw paths to point to the unpacked version.
Next you need to enable shadow editing (prefs/editing/part editing)
Then locate the camera part and edit it by clicking its edit icon like any normal model.
Snap information is visible by wireframes, you can click and move them around.
Click the tube shaped like an 'I' and press enter (or click the coordinate panel).
Change the sections parameter from R 6 10 to R 6 14
Save the file.
NOTE :this will also save the original part .dat if it had (auto) changes, you can prevent that by using complete.zip without unpacking it.

Or wait on 1.6b