MLCad 3.50 is available

[Jaco van der Molen]

Snapping all parts that a minifig can hold and fit in a minifig hand would be nice, not all parts do that.
Since recently I tried to get a minifig to hold a camera, but that part did snap to the hand. This one:

The snapping point on that has a length of 10 while the minifig hand clip has a length of 12 so the engine (correctly) decides it won't fit

I'll change it to 12 although it will then allow for overlap depending on the orientation of the hand.

Found how to add Bufferexchange in LDCad! Never gave it any thought nor did I knew how to do that .

Thanks for adjusting the snapping information. How to implement this now?