Steffen Wrote:I agree with you that we should get the hoses out.
However, this specific file is not needed to do that.
Both its number (75-1.dat) and contents (1 LDU long hose) make no sense.
Instead, simply the subparts s01 and s02 are sufficient
to create hoses of different length.
Regarding the "Mid" element of these, that is similar to a cyli primitive.
So it should be placed and scaled like that, even independently
from the discussion whether or not to add other LSYNTH parts
to the library.
So that file should be placed as follows: origin at top,
extending down 1 LDU vertically.
This will allow using that file like a cyli primitive.
When at a later point a decision about LSYNTH may be done,
that file will fit well, as that positioning following
our usual primitives orientation and placement
will also match LSYNTH fine.
So here are the steps we should take to get the hoses out:
(a) delete this file
(b) check that the middle section subfile matches the above
origin placement and orientation
© check that the end subfile has its origin also properly placed
(d) certify :-))))
I've copied this from the PT as I agree.
But I'll add:
(e) Make the 3L part and check name (as discussed here), origin etc.
(f) Certify
(g) Put remaining lengths on PT from auto-generator
(h) Certify quickly