So, I have a question regarding LPub3D, or rather using the available meta commands in a specific way.
I have a submodel that is 'formed'; all hinges are rotated. Then I have a copy of that submodel which is non-formed; completely straight. I want LPub to generate instructions for the non-formed version, but then showing the formed version in the assembly. I hope that makes sense to anyone.
Is there a way to do this? I can vaguely remember I did something like this in the past, but I wasn't able to find my implementation so I'm not sure it's even possible. Any ideas?
I have a submodel that is 'formed'; all hinges are rotated. Then I have a copy of that submodel which is non-formed; completely straight. I want LPub to generate instructions for the non-formed version, but then showing the formed version in the assembly. I hope that makes sense to anyone.
Is there a way to do this? I can vaguely remember I did something like this in the past, but I wasn't able to find my implementation so I'm not sure it's even possible. Any ideas?