LDCad 1.6 Beta 2 (win+linux)

[Philippe Hurbain]

I find it very annoying if the grid is vertical when using snapping, also it hurts the match finding it is doing somewhat as the location of the new part highly influences that.

Probably because I mainly do Technic where there is no vertical in assemblies (even if the model has one!)

If a part doesn't "go where you want it" try rotating the camera a bit. This is possible while holding a new part in "mid air" using the right mouse button, just keep the left mouse button pressed too.

Ah! nice to know. I used to drop the part before rotating the view.