I was working on the new Plate 2x2 without Corner (26601) using the exisiting larger plates 2450 and 30503 as a starting point.
I noticed that the existing parts are designed around the cutouts on the 45-degree corner in such a way that some editors, LDCad among them, show holes in the surface of the part. Is this a problem with LDCad or the existing parts? Are they still viable as a base for the new 26601 part?
I attached my current design to this post.
I noticed that the existing parts are designed around the cutouts on the 45-degree corner in such a way that some editors, LDCad among them, show holes in the surface of the part. Is this a problem with LDCad or the existing parts? Are they still viable as a base for the new 26601 part?
I attached my current design to this post.