RE: Wrapping tepee cover
2016-11-14, 16:16 (This post was last modified: 2016-11-14, 16:17 by Philippe Hurbain.)
2016-11-14, 16:16 (This post was last modified: 2016-11-14, 16:17 by Philippe Hurbain.)
Using a small drill bit... Support holes are now there, remains the entrance hole.
Big problem: the flat and formed files are now a soup of tri/quads, and I have no idea how to sort both files in the same order to generate a LPC template. LPC template which is usable only if precision issue is fixed anyway...
If LPC is fixed, the best bet is probably to make a template from undrilled files, and drill again the patterned version. If it is not, then the best solution is probably to make pattern from side projections (4 sides) and repair pattern at junctions with LDPE. Drawback of the last method, no flat version is generated as a by-product.
Big problem: the flat and formed files are now a soup of tri/quads, and I have no idea how to sort both files in the same order to generate a LPC template. LPC template which is usable only if precision issue is fixed anyway...
If LPC is fixed, the best bet is probably to make a template from undrilled files, and drill again the patterned version. If it is not, then the best solution is probably to make pattern from side projections (4 sides) and repair pattern at junctions with LDPE. Drawback of the last method, no flat version is generated as a by-product.