32004b - Need advice.
2011-12-10, 21:43 (This post was last modified: 2011-12-18, 19:16 by Damien Roux.)
2011-12-10, 21:43 (This post was last modified: 2011-12-18, 19:16 by Damien Roux.)
As stated on the tracker, I'm reworking this part (which according to Philo seems to have a lot of problems).
Problem is I do not own the part, but I've made assumptions and created it with a CAD software. With stl2dat, I've made a ldraw file.
Can some of you have a look and tell me what do you think of the pin-holes and axe-hole positions and dimensions (especially in the Z direction).
Then, if you compare with the tyre that goes with it (32003), the two parts don't seem to have the same diameters. Which one do you think is the correct one?
I know the part is very heavy and doesn't have any primitive but this is just a temporary file to first see if the geometry is correct.
Last question: if I rework the part from scratch: do I need to keep the name of the first author and put mine only in the file history?
Problem is I do not own the part, but I've made assumptions and created it with a CAD software. With stl2dat, I've made a ldraw file.
Can some of you have a look and tell me what do you think of the pin-holes and axe-hole positions and dimensions (especially in the Z direction).
Then, if you compare with the tyre that goes with it (32003), the two parts don't seem to have the same diameters. Which one do you think is the correct one?
I know the part is very heavy and doesn't have any primitive but this is just a temporary file to first see if the geometry is correct.
Last question: if I rework the part from scratch: do I need to keep the name of the first author and put mine only in the file history?