(2016-08-17, 16:08)Magnus Forsberg Wrote:(2016-08-16, 23:11)Willy Tschager Wrote: where does this information come from? Cannot find anything related among the specs.
It might look very "official", but that's only because I wrote it like that.
I'm also missing this in the specs.
(2016-08-17, 4:12)Travis Cobbs Wrote: All the size units in other part names are stud sizes, aren't they?
Yes.
1 stud = 1 brick = 20 ldu
I would say this is the correct way to describe the dimensions of a sticker.
(2016-08-17, 15:39)Chris Dee Wrote: OK - I suggest adding another bullet point in second place to read:
- Dimensions should be specified in studs (where 1 stud = 20LDraw units), rounded to one decimal place, as [z-dimension] x [x-dimension].
Yes, please, do that.
Done.
Chris (LDraw Parts Library Admin)