Gerald Lasser Wrote:At Digital-Bricks there are a number of the figure parts, exported from LDD.
Among them is also the part you require
But note, if this is done by a part author, the origin might change, although in my opinion the origin is pretty good.
So in the meantime you could use this part.
Thanks Gerald! Didn't run across that site in my searches, it's bookmarked now. Still learning a lot about parts so this will be handy.
Philippe Hurbain Wrote:Origin is good indeed (though placing it in the middle of the ball would not be stupid either), but orientation doesn't match other similar parts. Better use attached version, 90° rotated around Y.Thanks Philippe. Works like a charm!