Help on authoring x151 (Square Rubber Belt)
2015-11-01, 13:37 (This post was last modified: 2015-11-01, 21:30 by Damien Roux.)
2015-11-01, 13:37 (This post was last modified: 2015-11-01, 21:30 by Damien Roux.)
Hi there,
I would like to author x151 part.
![[Image: x151.jpg]](http://img.bricklink.com/PL/x151.jpg)
From what I've found on the tracker there is the x223.dat serie that exists, but in a formed shape.
I want it with no constrain, which is basically a 3 dimensions ring.
From what I've found the belt dimensions are 15mm / 1.6mm.
You can find attached what I've made so far.
Question is, how can I make primitive substitution in ldview not look ugly? I am not able to find primitive rings fullfilling this part dimensions.
I would like to author x151 part.
From what I've found on the tracker there is the x223.dat serie that exists, but in a formed shape.
I want it with no constrain, which is basically a 3 dimensions ring.
From what I've found the belt dimensions are 15mm / 1.6mm.
You can find attached what I've made so far.
Question is, how can I make primitive substitution in ldview not look ugly? I am not able to find primitive rings fullfilling this part dimensions.