LDraw.org Discussion Forums › General › Official File Specifications/Standards v
Slope Meta Command

Slope Meta Command


Gerald Lasser Offline
Administrator *******
Administrators James Jessiman Memorial LDraw Member PTAdmin PTSubmit Steering Committee
Posts: 1,723
Threads: 79
Joined: Sep 2011
Re: Slope Meta Command
#3
2015-10-21, 11:59
I think there should be a BEGIN and END statement as there are pieces which have a print on those textured faces and those will consist of many triangles.
Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Slope Meta Command - by Orion Pobursky - 2015-10-21, 1:59
Re: Slope Meta Command - by Travis Cobbs - 2015-10-21, 4:37
Re: Slope Meta Command - by Gerald Lasser - 2015-10-21, 11:59
Re: Slope Meta Command - by Roland Melkert - 2015-10-21, 16:49
Re: Slope Meta Command - by Travis Cobbs - 2015-10-22, 4:21
Re: Slope Meta Command - by Orion Pobursky - 2015-10-22, 4:48
Re: Slope Meta Command - by Gerald Lasser - 2015-10-22, 7:08
Re: Slope Meta Command - by Roland Melkert - 2015-10-22, 16:30
Re: Slope Meta Command - by Michael Horvath - 2015-10-26, 0:03
Re: Slope Meta Command - by Orion Pobursky - 2015-10-26, 4:20
Re: Slope Meta Command - by Roland Melkert - 2015-10-26, 19:10
Re: Slope Meta Command - by Ben Supnik - 2015-11-18, 1:58
Re: Slope Meta Command - by Roland Melkert - 2015-11-18, 20:45
Re: Slope Meta Command - by Orion Pobursky - 2015-11-19, 2:39
Re: Slope Meta Command - by Roland Melkert - 2015-11-19, 18:10
Re: Slope Meta Command - by Ben Supnik - 2015-11-20, 1:15
Re: Slope Meta Command - by Roland Melkert - 2015-11-20, 18:48
Re: Slope Meta Command - by Ben Supnik - 2015-11-25, 15:57
Re: Slope Meta Command - by Magnus Forsberg - 2015-11-19, 17:34
Re: Slope Meta Command - by Roland Melkert - 2015-11-19, 18:18

Forum Jump:


Users browsing this thread: 1 Guest(s)