Thanks Rolf for your input.
Personally if a part doesn't exist I would still like to see it converted in a either non official or non existing Ldraw part because:
1) it might be available at some point later on
2) it points out in Ldraw about missing parts, which is the only way to alert the user that the conversion wasn't possible on 100% of the parts.
This is actually my biggest problem with the conversion done in LDD: there is no final report or even a way to log the conversion details to file :-(
But as you also said these are just opinions/preferences.
- Mattia
Personally if a part doesn't exist I would still like to see it converted in a either non official or non existing Ldraw part because:
1) it might be available at some point later on
2) it points out in Ldraw about missing parts, which is the only way to alert the user that the conversion wasn't possible on 100% of the parts.
This is actually my biggest problem with the conversion done in LDD: there is no final report or even a way to log the conversion details to file :-(
But as you also said these are just opinions/preferences.
- Mattia