Agreed. Tolerance spec for sharp angles is 0.025 degrees min.
T-junction or sharp angle?
« Next Oldest | Next Newest »
| Messages In This Thread |
|
T-junction or sharp angle? - by Ronald Vallenduuk - 2015-09-23, 22:43
Re: T-junction or sharp angle? - by Damien Roux - 2015-09-24, 5:11
Re: T-junction or sharp angle? - by Philippe Hurbain - 2015-09-24, 6:49
Re: T-junction or sharp angle? - by Roland Melkert - 2015-09-24, 16:54
Re: T-junction or sharp angle? - by Philippe Hurbain - 2015-09-24, 17:22
Re: T-junction or sharp angle? - by Michael Heidemann - 2015-09-24, 18:23
Re: T-junction or sharp angle? - by Roland Melkert - 2015-09-24, 18:31
Re: T-junction or sharp angle? - by Ronald Vallenduuk - 2015-09-24, 22:35
Re: T-junction or sharp angle? - by Max Martin Richter - 2015-09-25, 5:27
Re: T-junction or sharp angle? - by Roland Melkert - 2015-09-25, 17:31
Re: T-junction or sharp angle? - by Travis Cobbs - 2015-09-25, 17:36
Re: T-junction or sharp angle? - by Max Martin Richter - 2015-09-25, 17:59
|
Users browsing this thread: 2 Guest(s)