DATHeader has a function to detect flat files that are scaled in the flat direction.
This is not an error that has any visual effect, but might be worse for some other calculations. Therefore I introduced that function in DATHeader. I used a tolerance value to minimize the wrong notifications.
LPE now finds errors in files that DATHeader accept for being correct.
I think both applications should use the same idea for finding these errors to avoid confusing the users.
Please see: http://www.ldraw.org/cgi-bin/ptdetail.cg...ts/272.dat
Any comments are very welcome.
cu
Mike
This is not an error that has any visual effect, but might be worse for some other calculations. Therefore I introduced that function in DATHeader. I used a tolerance value to minimize the wrong notifications.
LPE now finds errors in files that DATHeader accept for being correct.
I think both applications should use the same idea for finding these errors to avoid confusing the users.
Please see: http://www.ldraw.org/cgi-bin/ptdetail.cg...ts/272.dat
Any comments are very welcome.
cu
Mike