Just playing around with the parts bin configuration files, and I've noticed a small bug. Not sure if it's been there since Alpha 1, but I don't remember reading anyone mentioning it.
When the part bin is wider than it is long, the header bits (tab numbers, filter status, etc) switch to the side. This is great. However, when in that configuration, when you hover over a different view number (to change views) the view name turns green, but the text doesn't change to show you the name of the view you're about to select (as it does when the header bits are on the top). You have to check the status bar at the bottom to see what your new view is going to be if you don't remember what you put there.
Owen.
When the part bin is wider than it is long, the header bits (tab numbers, filter status, etc) switch to the side. This is great. However, when in that configuration, when you hover over a different view number (to change views) the view name turns green, but the text doesn't change to show you the name of the view you're about to select (as it does when the header bits are on the top). You have to check the status bar at the bottom to see what your new view is going to be if you don't remember what you put there.
Owen.