Gerald,
I refactored the sort routines and discovered (for example) the colour '8' was sorted higher than '70'. This as been fixed in the now available patch 1.2.1. Note the meta command for sort colour is now "Sort Color" (it was Sort Colour).
Regarding your out of place part, this is not a sorting issue, in fact, it is related to the packing routine. Using the grabber (the black square at the bottom of the PLI border when selected) to adjust the PLI area will 'automatically' move the out-of-place part to the sorted location; however, be mindful that other parts may shift so you'll have to play around with the adjustments until you are satisfied.
Let me know if you encounter any more issues. I did not play all the combinations of PLI/BOM sorting and constraints.
Here is a comparison of the Spirograph_ fW_v26_LPUB3D-2.mpd BOM:
After:
Before:
Best,
Trevor
I refactored the sort routines and discovered (for example) the colour '8' was sorted higher than '70'. This as been fixed in the now available patch 1.2.1. Note the meta command for sort colour is now "Sort Color" (it was Sort Colour).
Regarding your out of place part, this is not a sorting issue, in fact, it is related to the packing routine. Using the grabber (the black square at the bottom of the PLI border when selected) to adjust the PLI area will 'automatically' move the out-of-place part to the sorted location; however, be mindful that other parts may shift so you'll have to play around with the adjustments until you are satisfied.
Let me know if you encounter any more issues. I did not play all the combinations of PLI/BOM sorting and constraints.
Here is a comparison of the Spirograph_ fW_v26_LPUB3D-2.mpd BOM:
After:
Before:
Best,
Trevor