This isn't a bug but nonetheless a bit annoying:
* Drawing a curve, it would be useful if you could define the number of vertices also at the beginning and change the number once the end point is set. This most true in those cases where you draw more sections and the number of vertices gets stored in between. This is even more annoying when you finish with say 2 or 3 vertices only and start a new curve - you simlpy lack accuracy.
* It's not possible to select the vertices of the templates say to divide a line. You have to get rid off the template in order to do that.
* It would be nice if you could set the snap via toolbar buttons instead of the a bit cryptic (1/1000 LDU). At least for 1, 10, 100, 1000.
w.
* Drawing a curve, it would be useful if you could define the number of vertices also at the beginning and change the number once the end point is set. This most true in those cases where you draw more sections and the number of vertices gets stored in between. This is even more annoying when you finish with say 2 or 3 vertices only and start a new curve - you simlpy lack accuracy.
* It's not possible to select the vertices of the templates say to divide a line. You have to get rid off the template in order to do that.
* It would be nice if you could set the snap via toolbar buttons instead of the a bit cryptic (1/1000 LDU). At least for 1, 10, 100, 1000.
w.
LEGO ergo sum