I should propably also mention that I used the 2-8sphe.dat, from the official 'p' library, to test if I could make conitional lines with Edger2. I exported it as "LDRAW Primitives" from MLCAD and deleted the existing edge & condlines from the part.
LDraw.org Discussion Forums
›
Models and Parts
›
Parts Authoring
Smoothing and BFC problems in LDview
Smoothing and BFC problems in LDview
Smoothing and BFC problems in LDview
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Smoothing and BFC problems in LDview - by Mikkel Bech Jensen - 2015-02-19, 18:04
Re: Smoothing and BFC problems in LDview - by Mikkel Bech Jensen - 2015-02-19, 18:12
Re: Smoothing and BFC problems in LDview - by Philippe Hurbain - 2015-02-19, 18:19
Re: Smoothing and BFC problems in LDview - by Mikkel Bech Jensen - 2015-02-19, 20:52
Re: Smoothing and BFC problems in LDview - by Mikkel Bech Jensen - 2015-02-19, 21:03
Re: Smoothing and BFC problems in LDview - by Philippe Hurbain - 2015-02-20, 8:11
Re: Smoothing and BFC problems in LDview - by Gerald Lasser - 2015-02-19, 22:27
|
Users browsing this thread: 4 Guest(s)