Roland Melkert Wrote:R1 will cause division by zero problems if only Y differs between the two points.
Yes. There should be a special case for RX=RX=0. In that case
1 16 X1 Y1 Z1 1 0 0 0 0 -1 0 RY 0 cyli.dat
should work.
Tim
Drawing a cylinder from A to B
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Drawing a cylinder from A to B - by Wolstan Dixie - 2014-11-27, 14:56
Re: Drawing a cylinder from A to B - by Tim Gould - 2014-11-27, 22:13
Re: Drawing a cylinder from A to B - by Roland Melkert - 2014-11-27, 22:37
Re: Drawing a cylinder from A to B - by Wolstan Dixie - 2014-11-28, 0:00
Re: Drawing a cylinder from A to B - by Tim Gould - 2014-11-28, 4:11
Re: Drawing a cylinder from A to B - by Wolstan Dixie - 2014-11-28, 12:15
|
Users browsing this thread: 3 Guest(s)