Ok, now I know what happened.
There has been a discussion for the colors mentioned in the part title for Physical Colour Parts.
As far as I remember nobody knows which colours are meant (bricklink or peeron) so the number from ldconfig.ldr in brackets should be used (f.e. [7]).
This is tested by DATHeader.
The next release will test this only on parts. Sourcecode is already fixed.
I hope this answers your question.
Edit:
I just searched the base of this test and found the following:
1) Anouncement for version 3.0.12.0 of DATHeader 03. Oct. 2013 (http://forums.ldraw.org/showthread.php?t...5#pid10125)
2) Question for new tests for DATHeader 21. Sep. 2013 (http://forums.ldraw.org/showthread.php?t...7#pid10047)
3) Discussion on the PT (http://www.ldraw.org/cgi-bin/ptdetail.cg...173283.dat)
There has been a discussion for the colors mentioned in the part title for Physical Colour Parts.
As far as I remember nobody knows which colours are meant (bricklink or peeron) so the number from ldconfig.ldr in brackets should be used (f.e. [7]).
This is tested by DATHeader.
The next release will test this only on parts. Sourcecode is already fixed.
I hope this answers your question.
Edit:
I just searched the base of this test and found the following:
1) Anouncement for version 3.0.12.0 of DATHeader 03. Oct. 2013 (http://forums.ldraw.org/showthread.php?t...5#pid10125)
2) Question for new tests for DATHeader 21. Sep. 2013 (http://forums.ldraw.org/showthread.php?t...7#pid10047)
3) Discussion on the PT (http://www.ldraw.org/cgi-bin/ptdetail.cg...173283.dat)