In case of the socket you are right, but the clip is clearly visible when using solid colors.
I noticed all this while adding support for part snapping 'irregular shaped' things in LDCad, so I'm not completely sure where the connector should be placed in the first place.
In the pictures it's as far back as it goes, which seems to agree with how LDD places it. Although it sticks out somewhat more over there, the wires origin are at the same location I think.
Maybe the correct question for this thread was where they should be in relation to each other. In that case could some one move the thread please.
I noticed all this while adding support for part snapping 'irregular shaped' things in LDCad, so I'm not completely sure where the connector should be placed in the first place.
In the pictures it's as far back as it goes, which seems to agree with how LDD places it. Although it sticks out somewhat more over there, the wires origin are at the same location I think.
Maybe the correct question for this thread was where they should be in relation to each other. In that case could some one move the thread please.