Since all studs should always be oriented the same direction in one part, perhaps we could use a meta-command to apply stud orientation per-part? i.e. provide a rotation matrix for stud-logo.dat. This solution would only work with non-SNOT parts but should be good enough I think?
A 3/4-stud or not?
« Next Oldest | Next Newest »
| Messages In This Thread |
|
A 3/4-stud or not? - by Magnus Forsberg - 2014-07-15, 12:01
Re: A 3/4-stud or not? - by Santeri Piippo - 2014-07-15, 12:46
Re: A 3/4-stud or not? - by Chris Dee - 2014-07-15, 17:10
Re: A 3/4-stud or not? - by Magnus Forsberg - 2014-07-16, 10:42
Re: A 3/4-stud or not? - by Steffen - 2014-07-16, 6:59
Re: A 3/4-stud or not? - by Santeri Piippo - 2014-07-16, 9:56
Re: A 3/4-stud or not? - by Mark Kennedy - 2014-08-17, 12:57
|
Users browsing this thread: 1 Guest(s)