Chris Dee Wrote:Yes, please use 11767 instead of 11125c01. I wasn't aware that we knew the number for the assembly.
Each separate physical element should be a separate LDraw file - so yes, the axle (trivial though it is) should be a separate file. The uNNNN numbers are used where we don't know the LEGO Design ID for the part see here. Regular authors can request (from me) a block of uNNNN number, or I assign them individually as required. There is no inherent meaning to u9081, so please use that for the tyre and u9082 for the axle.
Hallo,
after a little while I worked on a hi-res version of 11140 as recommended by Santeri Piippo which renders much more beautiful than my previous one.
But before I upload my parts one more question: do I have to model the outer cylinder of this wheel? It will never be visible, apart from that I don't know the shape of the wheel under the rubber. Same question for the axlehole: you never will see it in the complete part 11767, so do I have to model it? Please see the 2 pics.
regards, Ingolf