Neither of these parts 6881a and 6881b are on the official library yet.
Please remember the mantra of the Parts Tracker "These are unofficial parts. They may be incomplete, or inaccurate, and it is possible that when they are officially released they may be changed in ways that could mess up any model you use them in.". That still applies even though a part may be Certified, as these are.
You raise a good point about sorting, and one that we probably don't pay enough attention to. For this reason, I am minded to re-title these and add Scala as a KEYWORD.
I think it is good to raise general philosophical points on this forum, but I'd really prefer that comments on individual files on the Parts Tracker are posted there so that everyone who has contributed to their development or review is notified through the daily PT digest.
Part names should be descriptive of form and function, and for this reason, I think "Scala" still has a place as a CATEGORY for parts that use a Scala Stud. However, of the exsting 9 Scala parts in the official library not all do.
I'll re-cycle the two existing "Scala Tiles" for header correction. Others could benefit from a re-examination.
Chris
Please remember the mantra of the Parts Tracker "These are unofficial parts. They may be incomplete, or inaccurate, and it is possible that when they are officially released they may be changed in ways that could mess up any model you use them in.". That still applies even though a part may be Certified, as these are.
You raise a good point about sorting, and one that we probably don't pay enough attention to. For this reason, I am minded to re-title these and add Scala as a KEYWORD.
I think it is good to raise general philosophical points on this forum, but I'd really prefer that comments on individual files on the Parts Tracker are posted there so that everyone who has contributed to their development or review is notified through the daily PT digest.
Part names should be descriptive of form and function, and for this reason, I think "Scala" still has a place as a CATEGORY for parts that use a Scala Stud. However, of the exsting 9 Scala parts in the official library not all do.
Code:
6923.dat:0 Scala Tile 8 x 20 x 2/3 Round Ends
6934.dat:0 Scala Tile 3 x 6
6940.dat:0 Scala Bed 8 x 24
6965.dat:0 Scala Table 7 x 7 x 1 & 1/3
6969.dat:0 Scala Towel Bar 1 x 5
33008.dat:0 Scala Flower Pot
33029.dat:0 Scala Plate 2 x 4
33062.dat:0 Scala Plate 4 x 4
33089.dat:0 Scala Support 4 x 4 x 5.667I'll re-cycle the two existing "Scala Tiles" for header correction. Others could benefit from a re-examination.
Chris
Chris (LDraw Parts Library Admin)