Quote:Yes but isn't using the axle.dat in situations where you will never see one side of it's outer triangles somewhat misusing. Like e.g. the 57585.dat part.I don't see the problem when part is not transparent...
Quote:I somehow (maybe wrongly) expected them to use a single connhole.datHistory...
Peghole is there from the beginning, Beamhole was put on PT on 2004-11-07, Connhole was put on PT on 2007-12-02. Most beams were created before 2007, so they couldn't use connhole (except if they were updated).
Quote: I can't add snap info to peghole.dat cause you don't know what that single 'flat' shape is used for at the part level.Mmhhh... indeed it doesn't describe length of hole - I guess that's what you mean - but it is not flat. And AFAIK was only used as Technic hole entry (that's not the case for stud.dat that has been used a lot as a capped cylinder, but hopefully we got rid of this).