redesign of official part
2011-10-05, 22:53 (This post was last modified: 2011-10-06, 16:40 by Christian Neumann.)
2011-10-05, 22:53 (This post was last modified: 2011-10-06, 16:40 by Christian Neumann.)
hi,
i accidentally built a little part that already exists in the official library. The number has been changed from 52 to 30385, but when i recognized that it was too late... :S
However, the existing part has slightly incorrect proportions, some gaps, a lot of t-junctions and no bfc. Is there a way to update the existing part, although i recreated it from scratch? If so, what do i have to put into the header (orig. author, history, etc.)?
greets,
Christian
i accidentally built a little part that already exists in the official library. The number has been changed from 52 to 30385, but when i recognized that it was too late... :S
However, the existing part has slightly incorrect proportions, some gaps, a lot of t-junctions and no bfc. Is there a way to update the existing part, although i recreated it from scratch? If so, what do i have to put into the header (orig. author, history, etc.)?
greets,
Christian