Conditional lines on part cylinders


Re: Conditional lines on part cylinders
#3
Quote:If you add a tangential face to the cyli, then the control point matches this face.
It also works if you join too partial cylinders together, as those side condlines complement each other. So for most usages, these condlines are OK and avoid the hassle of creating them.
It's only when you join to a surface not tangent that you need to add another condline.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Conditional lines on part cylinders - by Philippe Hurbain - 2013-10-17, 8:41

Forum Jump:


Users browsing this thread: 1 Guest(s)