Solved: Change the representation in the PLI
2 hours ago (This post was last modified: 49 minutes ago by Manfred Schaefer.)
2 hours ago (This post was last modified: 49 minutes ago by Manfred Schaefer.)
Hello,
I'm using part 24093p03 in a set of assembly instructions in LPub3D. The representation in the PLI is unsuitable. The page with the pattern isn't visible.
Pic1.JPG (Size: 4.85 KB / Downloads: 15)
So I wanted to change this representation and created a corresponding entry in the PLI.mpd file.
Pic2.JPG (Size: 17.49 KB / Downloads: 13)
However, it didn't work.
How can I get LPub3D to use the new representation in the PLI?
Thank you.
Best regards,
Manfred
Edit:
I figured out the solution on my own. Although I restarted LPub3D each time I made changes to the pli.mpd file, the problem was actually the LPub3D working directory, which is created by LPub3D itself. This directory contains the rendered images, and LPub3D likely didn't re-render the page because it didn't detect any changes.
Pic3.JPG (Size: 4.8 KB / Downloads: 4)
I'm using part 24093p03 in a set of assembly instructions in LPub3D. The representation in the PLI is unsuitable. The page with the pattern isn't visible.
Pic1.JPG (Size: 4.85 KB / Downloads: 15)
So I wanted to change this representation and created a corresponding entry in the PLI.mpd file.
Pic2.JPG (Size: 17.49 KB / Downloads: 13)
However, it didn't work.
How can I get LPub3D to use the new representation in the PLI?
Thank you.
Best regards,
Manfred
Edit:
I figured out the solution on my own. Although I restarted LPub3D each time I made changes to the pli.mpd file, the problem was actually the LPub3D working directory, which is created by LPub3D itself. This directory contains the rendered images, and LPub3D likely didn't re-render the page because it didn't detect any changes.
Pic3.JPG (Size: 4.8 KB / Downloads: 4)