Make Part 45590 Flexible

[Gerald Lasser]

Here's a proposal to make this rubber part from flexible k0x parts

In the new Slave-1 this part is used to attach the side panels to the structure, streching the part a bit, respectively taking advantage of the flexibility.

All parts are in the ZIP

45590_v2 is the standard one

45590_Test as it is used on the Slave-1

While doing so, I added the slight curve on the part

[Philippe Hurbain]

Here's a proposal to make this rubber part from flexible k0x parts

In the new Slave-1 this part is used to attach the side panels to the structure, streching the part a bit, respectively taking advantage of the flexibility.

All parts are in the ZIP

45590_v2 is the standard one

45590_Test as it is used on the Slave-1

While doing so, I added the slight curve on the part

Tough one, I'm afraid I don't master enough LDCad templates making
Here's what I've done so far, but I'd like to hear Roland on this question!

Otherwise, I think the segments should contain a "skirt" going inside the part to allow overlaps between segments and mask the junctions

[Gerald Lasser]

How do I get it to work?

Just copy it to "\AppData\Roaming\LDCad\templates\path"?

and the donor files to the Unofficial dir?

[Philippe Hurbain]

How do I get it to work?

Just copy it to "\AppData\Roaming\LDCad\templates\path"?

and the donor files to the Unofficial dir?

Yes, exactly! But as suggested above this template doesn't give very good results 😥

[Gerald Lasser]

I see your spike templates (which I copied als at the same time), but I fail to see this one although they are all in the same dir, strange.

GOtit working, I needed to add KEYWORD flexible to the file