+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: LDraw Programs (https://forums.ldraw.org/forum-7.html)
+--- Forum: LDraw File Processing and Conversion (https://forums.ldraw.org/forum-22.html)
+--- Thread: Can't Scale Callout LPUB4 (/thread-2239.html)
Can't Scale Callout LPUB4 - Chris Eyerly - 2011-12-09
I've been using both the official LPUB 4.0.0.10 from Sourceforge and LPUB 4.0.0.12 compiled by Ramón as mentioned in a previous thread. Here is my issue, I have a set of directions that start with a submodel x2. Then it is finished with the taking the the 2 submodels and connecting them with some additional pieces. (File attached) My issue is that when I do "Add assembled image to parent page", It gives me a callout appropriately on pg 12, counting the cover. The callout is WAY too big, but there is no way to scale it. When I right click on the assembly in the callout, and choose "change scale" the callout doesn't change.
Does anyone know how to fix this? I'm assuming there are some metacommands I put right in the file, but I looked through the list of metacommands from the help menu, and couldn't figure it out.
Thanks!
Chris Eyerly