Hi there,
this time it's the 1988's Test Car Technic model 8865. It should be OMR compliant, but there are known issues:
- Small mismatch for 16-technic-brick (3703) which connects the front frame to the roof in the last step. As far as I can see and calculate with CAD, this seems to be "desired margin" in the real build. Did I something wrong, is there a way to make it look "better matching"?
- The steering axle angles with two universal joint (2x 3712+3326b+3712) in steps 16/17 are not acceptable. I looked at the angles provided by "Selection Info" without luck - I will fix this as soon as possible and would welcome any suggestion.
Done with LDCad 1.6c (Linux64).
Thanks in advance for any improvement suggestion!
Regards
Stefan
(2019-11-27, 21:27)Stefan Frenz Wrote: [ -> ]Hi there,
this time it's the 1988's Test Car Technic model 8865. It should be OMR compliant, but there are known issues:
- Small mismatch for 16-technic-brick (3703) which connects the front frame to the roof in the last step. As far as I can see and calculate with CAD, this seems to be "desired margin" in the real build. Did I something wrong, is there a way to make it look "better matching"?
- The steering axle angles with two universal joint (2x 3712+3326b+3712) in steps 16/17 are not acceptable. I looked at the angles provided by "Selection Info" without luck - I will fix this as soon as possible and would welcome any suggestion.
Done with LDCad 1.6c (Linux64).
Thanks in advance for any improvement suggestion!
Regards
Stefan
The “mismatch” you refer to is exactly the scenario that prompted me to post
this thread.
And in my own 8865 model, the u-joint issue was handled using the advice given in
this thread—which was inspired by my efforts to build the original Auto Chassis.
(2019-11-28, 4:31)N. W. Perry Wrote: [ -> ]The “mismatch” you refer to is exactly the scenario that prompted me to post this thread.
And in my own 8865 model, the u-joint issue was handled using the advice given in this thread—which was inspired by my efforts to build the original Auto Chassis.
Thank you so much, this was exactly what I was looking for.
I will update my model accordingly.
(2019-11-28, 4:31)N. W. Perry Wrote: [ -> ]The “mismatch” you refer to is exactly the scenario that prompted me to post this thread.
And in my own 8865 model, the u-joint issue was handled using the advice given in this thread—which was inspired by my efforts to build the original Auto Chassis.
Now done and updated, thank you very much.
Remaining known issues: none
Regards - Stefan
(2019-11-28, 8:40)Stefan Frenz Wrote: [ -> ]Now done and updated, thank you very much.
Remaining known issues: none
Regards - Stefan
Hi Stefan
Following Problem:
There is a Part (submodell) missing:
Johann
(2019-12-26, 21:11)Johann Eisner Wrote: [ -> ]Following Problem:
There is a Part (submodell) missing:
Hi Johann,
thank you very much, attached is an updated version - the missing part was intentionally deleted because it was empty. I missed to delete the part ref...
Best regards
Stefan