Dumb Offical Part Question: Lines and Sharp Edges


Dumb Offical Part Question: Lines and Sharp Edges
#1
Hi Y'all,

Sorry for a whole pile of stupid spec q's, but...

Is there a requirement for official parts that all edges of a part be 'coated' with a line or conditional line?

I read that some programs use the presence or absence of lines to determine which mesh vertices should be smoothed across triangles, but I didn't see anything in the part authoring spec about the requirement that lines be present.

Is having lines on the edges something so basic and obvious to everyone that it didn't need to be stated? :-)

Thanks!!!
Ben
Reply
Re: Dumb Offical Part Question: Lines and Sharp Edges
#2
Short answer - yes Smile

Each corner should have an edgeline. If primitives meet (triangle or quats) at an angle to imitate a round structure you should put an optional line there.
Reply
Re: Dumb Offical Part Question: Lines and Sharp Edges
#3
Interior curves (where the curve can never trigger a conditional edge line that is visible on-screen) aren't required to have conditional lines on them. Many do because of LDView's smoothing relying on conditional edge lines. Many others do because they use primitives, and all curve primitives are allowed to be interior or exterior, so contain conditional edges. All creases are required to have edge lines (line type 2, color 24).
Reply
Re: Dumb Offical Part Question: Lines and Sharp Edges
#4
Thanks guys, and Travis, thanks for the link to the LDView exporter code.

I will look at line-based smoothing for BrickSmith...it seems that the line requrirement for sharp lines might be stronger than the conditional line requirement for non-sharp lines.
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)
Forum Jump:


Users browsing this thread: 1 Guest(s)