SW 3D meshes


Re: SW 3D meshes
#5
Thanks Wink
But I'm afraid that Kaadu will require a lot of work to get it right. There are many flat areas or ruled surfaces that will not look right if the mesh is simply downsampled. I think these areas should be redone by drawing edge lines around mesh used as guide, then build surfaces between these lines using Coverer.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
SW 3D meshes - by Philippe Hurbain - 2012-05-31, 8:35
Re: SW 3D meshes - by Philippe Hurbain - 2012-05-31, 19:35
Re: SW 3D meshes - by Philippe Hurbain - 2012-06-21, 19:10
Re: SW 3D meshes - by Greg Teft - 2012-06-21, 20:11
Re: SW 3D meshes - by Philippe Hurbain - 2012-06-22, 6:58
Re: SW 3D meshes - by Greg Teft - 2012-06-22, 12:38

Forum Jump:


Users browsing this thread: 1 Guest(s)