2D (ortho) editing


Re: 2D (ortho) editing
#21
Ok, another semi related opinion poll...

When changing the 'selection center' (aka rotation center) in a current selection, should it reset back to the main part center for the next selection (a deselect in between) or should it live on for ever (or at least while the application runs).

Cause this kinda bugged me in mlcad (sometimes you moved it by mistake, without even noticing).

But it also might be irritating when it resets unwanted all the time as well. I would like to make this somewhat smart without resorting to jet another option, any ideas?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
2D (ortho) editing - by Roland Melkert - 2012-05-03, 20:19
Re: 2D (ortho) editing - by Tim Gould - 2012-05-03, 21:30
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-03, 22:09
Re: 2D (ortho) editing - by Tim Gould - 2012-05-04, 0:52
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-04, 16:20
Re: 2D (ortho) editing - by Travis Cobbs - 2012-05-04, 18:04
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-04, 18:14
Re: 2D (ortho) editing - by Travis Cobbs - 2012-05-04, 18:23
Re: 2D (ortho) editing - by Willy Tschager - 2012-05-04, 12:08
Re: 2D (ortho) editing - by Philippe Hurbain - 2012-05-04, 12:23
Re: 2D (ortho) editing - by Steffen - 2012-05-04, 15:55
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-04, 16:05
Re: 2D (ortho) editing - by Steffen - 2012-05-04, 16:09
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-04, 16:38
Re: 2D (ortho) editing - by Travis Cobbs - 2012-05-04, 18:10
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-04, 18:27
Re: 2D (ortho) editing - by Tim Gould - 2012-05-04, 23:57
Re: 2D (ortho) editing - by Travis Cobbs - 2012-05-05, 17:36
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-06, 16:43
Re: 2D (ortho) editing - by Roland Melkert - 2012-05-12, 20:06

Forum Jump:


Users browsing this thread: 1 Guest(s)