Sticker Standard Questions


Re: Sticker Standard Questions
#5
Thanks for the answers, Willy.
I forgot all about searching for these answers in lugnet since I started back up with LDraw this winter!!!

That last post is quite the eye-opener.
I have to say, a strict, or nit-picking review is discouraging. Especially in the grey areas where the standard can not be used to mediate (sub-parts). The community should be happy people are still out here modelling, and not make this hobby painful. It's not a job!!!

I'll try just using a box for the back and see. I do think a 2 LDU radius isn't worth the overhead of pulling in the 1/4 cylinders, chords and discs, but I didn't want to be wrong.

With all the drive toward accuracy, I would think rounded corners, and white sides/back for white sticker sheets would be the preference!!! And looking at parts like the 1 x 1 plate w/ tooth, there's an edge line right down the middle of it, and it's not even a sharp edge!!!
- Greg
"The only stupid question is the one that remains unasked"
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Sticker Standard Questions - by Greg Teft - 2012-02-01, 7:10
Re: Sticker Standard Questions - by Greg Teft - 2012-02-01, 20:12
Re: Sticker Standard Questions - by Greg Teft - 2012-02-02, 3:01
Re: Sticker Standard Questions - by Greg Teft - 2012-02-02, 21:17

Forum Jump:


Users browsing this thread: 1 Guest(s)