Form Technic Axle Flexible with liftarms

[Jaco van der Molen]

These files are in my previous post (zip file). Are you sure you're using latest 1.7alpha2? Have you restarted LDCad after donnor file update?

Tricky isn't it?  
Actually, I used axle connexion to allow auto-orientation of part. A pin connection might work in non-twisted configuration, but otherwise it's better to use a part with axlehole and replace it later with a beam.

Oops, my mistake. I worked with LDCad 1.6d.

I have 1.7alpha2 too. That works better, but snapping is off sometimes.
Still, very promising. Thank you.

The only file in the zip is "twisted flex.mpd" BTW

[EDIT] Works good with axle holes, but then replacing with beams is difficult, since the center is elswhere.