Minor changes to the Official Library Spec


RE: Minor changes to the Official Library Spec
#12
(2021-07-24, 3:42)Willy Tschager Wrote: Agreed. Could you please update the wording and also rework the requirement of a set number in the KEYWORDS for both stickers and sticker shortcuts?

w.

OK:

Clarification to Sticker Geometry:
Quote:For stickers printed on a transparent medium, the type 1, 3, and 4 lines that comprise the pattern shall be preceded by a 0 BFC NOCLIP statement. If there is non-pattern geometry after the pattern geometry, the pattern geometry shall be ended by a 0 BFC CLIP statement.

The sticker should be oriented such that the top of the pattern aligns with the +Z axis. Exceptions to this rule may be made on a case by case basis.

New Sticker !KEYWORDS Entry section immediately following the Sticker Description section:
Quote:All stickers and sticker shortcuts should, at a minimum, include at least one !KEYWORDS entry in the form of Set <set number> where <set number> is the number of an official LEGO set in which that sticker appears. Only one set need be listed, but more may be if desired.

To reiterate what I said elsewhere, I don't have a strong opinion about this. I did the call for votes because it seemed fine, and there appeared to be consensus before I did it. I don't really plan to argue the merits of the above changes, but I would greatly appreciate it if anyone has problems with them, that they speak up before another call for votes happens.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Minor changes to the Official Library Spec - by Travis Cobbs - 2021-07-25, 0:56

Forum Jump:


Users browsing this thread: 1 Guest(s)