Part 63965


RE: Part 63965
#2
(2020-04-16, 17:20)N. W. Perry Wrote: Has anyone got a part 63965 handy and able to get some quick measurements? I think the short end of the bar combined with the stop ring should add up to 24 LDU, one full brick height. Currently it comes to 25.5 (of which 7.5 is the ring thickness and the remaining bar length is 18).

For an official usage showing this, see set 21028, step 73. The bar fits fully inside the Travis brick, flush to the top of its hollow stud (underside of the 1x1 plate), such that the 1x1 round brick can still snap on to the bottom.

I thought the same thing and then I pulled out the real part and compared. The length is correct.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Part 63965 - by N. W. Perry - 2020-04-16, 17:20
RE: Part 63965 - by Orion Pobursky - 2020-04-16, 17:58
RE: Part 63965 - by Magnus Forsberg - 2020-04-16, 20:00
RE: Part 63965 - by N. W. Perry - 2020-04-17, 3:19
RE: Part 63965 - by Magnus Forsberg - 2020-04-17, 7:44
RE: Part 63965 - by N. W. Perry - 2020-04-17, 16:25
RE: Part 63965 - by N. W. Perry - 2020-04-19, 15:15

Forum Jump:


Users browsing this thread: 1 Guest(s)