Complete 25195 Plate, Modified 2 x 6 with Pole Holder Pin


RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin
#14
(2020-04-16, 9:22)Magnus Forsberg Wrote: OK, great.
Here is a preview, of what I see on the images.
Is the height of the cylinder correct? I can't tell that from your images.
IMO the inside of the "handle with bars", 23422.dat , is too narrow. Don't think it is the same as a stud.
That upside down 1x1 brick didn't stick when you placed it on top of the cylinder. Right?
On the photos I measure 14 ldu for inner cylinder diameter. First photo shared by Lasse show a 32ldu cylinder height above plate. Actually, he just posted that Wink
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin - by Philippe Hurbain - 2020-04-16, 15:33

Forum Jump:


Users browsing this thread: 1 Guest(s)