Thanks Philippe. That was helpful.
I took one of the existing LQ parts (what does that stand for, anyway?) and in nested mode deleted everything except the cable and plug, which I can then position with the motor. I probably still have some things to figure out with respect to renaming the part so that the changes carry over to LPub3D. Any advice on that would be welcome.
I think I know how I can get Lpub3D to ignore the cable as a separate part, or maybe treat the motor + part submodel as a single part. Although it would be more elegant if I can turn the motor+cable into my own custom part.
My goodness, how far down does this LEGO rabbit hole go?
I took one of the existing LQ parts (what does that stand for, anyway?) and in nested mode deleted everything except the cable and plug, which I can then position with the motor. I probably still have some things to figure out with respect to renaming the part so that the changes carry over to LPub3D. Any advice on that would be welcome.
I think I know how I can get Lpub3D to ignore the cable as a separate part, or maybe treat the motor + part submodel as a single part. Although it would be more elegant if I can turn the motor+cable into my own custom part.
My goodness, how far down does this LEGO rabbit hole go?