Thinking about doing a LDCad 1.7 version


RE: LDCad 1.7 version: flex parts control points
#59
Here is the idea I have in mind:
   
Sensor, plug and blue brick are fixed, but of course the cable must avoid the brick. When I insert a new control point to get around the brick, I end up in the middle configuration, with a pinch in the cable. The "control point" smoothing function would somehow average (with some weighting depending on distance) the other two control points directions in order to set a "plausible" direction and twist.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LDCad 1.7 version: flex parts control points - by Philippe Hurbain - 2020-02-06, 7:27

Forum Jump:


Users browsing this thread: 2 Guest(s)