LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
(2022-02-24, 19:14)Roland Melkert Wrote: </snip>

Only difference with yours are the clip orientations which may come into play in a future version of the snapping engine.

Thanks Roland.

When I was tutu-ing with configuring the snap information for the part, I had played about with the orientation and decided it wasn't that significant. However, it is useful to know that there may be benefits to more properly orientating the clips.

It's interesting that the Y co-ordinate of two of the points are changed from 15 to 14. I thought the sprocket would be symmetrical (not that I actually checked!), which is why I used -15 and 15. Presumably s\57520s02.dat reflects the effective Y values as being -15 and 14 hence why you used those two values.

Regards,

David
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by David Manley - 2022-02-24, 22:08
RE: Part Snapping missing/errors - by SNIPE - 2022-07-22, 13:59

Forum Jump:


Users browsing this thread: 1 Guest(s)